Guys, Do any of you have any experience with Sophia SET 300b Mesh Plates? From what I gathered, user have said not t0 buy Gold Lion or BT, just save and get the Sophias... Just curious if they are that much better? Thanks, IDTs
my lm 508 ia just arrived i wil post some photo later there is something i want to ask what is the ideal bias point in lm 508 ia is it 120? about hum balancer do i need to adjust anything, how to see the hum balancer point
120 is the correct bias point (think that it should be listed on page 6 in the manual). Adjust the hum balancers as needed (if you have any hum, just turn until the hum quiets).
The reason I'm asking is because I had a fuse blow yesterday, but the fuse that was in it and the two spares were all different. I don't know which is the correct one.
He has a 518, and I believe you have a 508. They could be different, I'll try and check my demo unit for you tomorrow morning.
Yep....that's what I have as well. The label on the unit says 8amps, so I would think 8 should be ok. I'm going to shoot Tone Imports (Jonathan) a quick message and see what he thinks.....
GPA, I have over 300+ hours on my LM 508 IA and I'm loving the sound! Have you tested any pre-amps on the 508? Curious if there are improvement as noted on the 518... Thanks, IDT
Guys, I've replaced my stock Shuguang 805 tubes in my LM 508IA with Psvane 805A and it's an improvement across the board; lower floor noise, better bass, much improved imaging/sound-staging and a major decrease in chassis vibration noticed when touching the faceplate/sides. All of this is noted with just 5 hours of use and looking forward to a long night of listening... By the way, I have replaced all of the stock 508IA tubes IDT
here is my setup lm508ia with upgraded tube also Quantum Black Fuse 8A ps vane 300b TII Shugunag 805 AT Black Treasure Shuguang Globe 6SN7 Shuguang 6SL7 T Gold Pin With Audio Gd NOS 7 DAC the sound compared to standard tube and fuse is far Improved
Hi Again all I want to ask something , i have heard some hum coming from my both speaker with lm 508IA , like 60hz hum (the hum can only be heard when i put my ear in front my speaker like 10cm) . i have tried lifting the ground from the ac power cord , the hum still there. unplug all the interconnect cable (only speaker cable connected), the hum still there. adjusting hum balancer only decrease a little . strange thing using nfb 4 or 3 the hum decrease lot but still there have anyone experience this hum also? is it normal? thanks